Button # 1 Locks Keyless Entry (Momentary Press)
(Continuous Press, Over 3 Seconds)
Activates Channel # 3
Button # 2 Unlocks Keyless Entry
Button # 3 Activates Channel # 2
Button # 4 Activates Panic Mode

When the keyless entry module is locked,
the parking lights will flash once
and the LED will begin to flash.
The orange wire will provide a ground
output while the unit remains in the locked mode.
(for optional starter disable relay)

When the keyless entry module is unlocked,
the parking lights will flash twice and
the LED will go out. The dome light will
also illuminate for 15 seconds if the feature
has been installed. Pressing the unlock button
a second time will momentarily activate
the violet wire. The dome light will go out
immediately if the ignition is turned on
before the 15 seconds timer elapses.

CODE LEARNING:

To enter code learning - Turn the ignition
ON-OFF, ON-OFF, then ON,
the parking lights will flash once.
Press and hold the program switch until
the parking lights flash three times.
You are now ready to learn in new codes.

CODING EACH REMOTE

Press button # 1 of each remote to be coded.
The parking lights will flash once to confirm
each new code was received.

Note: If you are adding remotes and
want to keep the existing codes,
they must be re-coded every time the
code learning sequence is initiated.
A maximum of 3 codes can be learned.
To exit code learning - Turn the ignition key off

PROGRAM FEATURES LOCATION

(Follow The code learning proceure above)
Once you have entered the code learning mode
To change the feature settings,
follow these procedures

Once in Code Learning, To change
a feature setting, press the valet button
the same amount of times, as the setting
position you want to change,
then using the remote
press button 1 for feature on
press button 2 for feature off.

IE;
(after code learning mode is acheived
press the valet button once for first position,
twice for 2nd position etc...,
you will recieve a chirp from the siren,
confirming the feature you've selected to change
then press button 1 or 2 on the remote
for the desired feature option)

1# ON IGNITION AUTO LOCK
OFF NO IGNITON AUTO LOCK
#2 ON 1 PULSE FOR UNLOCK
OFF 2 PULSE FOR UNLOCK
#3 ON HORN CONFORMATION
OFF NO HORN CONFORMATION
#4 ON 1 Sec. LOCK/UNLOCK Pulse
OFF 3.5 Sec. LOCK/UNLOCK Pulse
Turn off ignition key to set features

RESET TO FACTORY DEFAULT SETTINGS

Turn the key on. Within 10 seconds
press the override switch 5 times.
Then press and release buttons 1 & 2
together for 5 seconds the light will flash 3 times.
All programable features will be back to the
factory default settings.

OPERATING INSTRUCTIONS

TRANSMITTER BUTTON OPERATION:
IMPORTANT:

The microprocessor Key - Less system has a ½ second built in delay. This is to give the electronics a chance to stabilize.

ACTIVE LOCKING MODE:

By pressing transmitter button #1 the doors will lock automatically, the lights will flash the LED will turn on and the Optional Starter Disable will be activated.

EMERGENCY OVERRIDE SWITCH: